tachtler:virtualisierung_installation_wirt-system_centos_7
Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Beide Seiten der vorigen RevisionVorhergehende ÜberarbeitungNächste Überarbeitung | Vorhergehende Überarbeitung | ||
tachtler:virtualisierung_installation_wirt-system_centos_7 [2014/12/09 09:50] – [Installation] klaus | tachtler:virtualisierung_installation_wirt-system_centos_7 [2014/12/09 10:02] (aktuell) – [/etc/sysconfig/libvirt-guests] klaus | ||
---|---|---|---|
Zeile 716: | Zeile 716: | ||
Nach der Installation sind folgende Änderungen zu überprüfen: | Nach der Installation sind folgende Änderungen zu überprüfen: | ||
* **Start der neuen Dienste beim Systemstart** | * **Start der neuen Dienste beim Systemstart** | ||
- | * libvirt-guests | + | * '' |
- | * libvirtd | + | * '' |
* **Start des Netzwerk-Interface '' | * **Start des Netzwerk-Interface '' | ||
Zeile 759: | Zeile 759: | ||
inet 192.168.122.1/ | inet 192.168.122.1/ | ||
| | ||
+ | </ | ||
+ | |||
+ | ===== Konfiguration ===== | ||
+ | |||
+ | ==== / | ||
+ | |||
+ | Mit dem Dienst '' | ||
+ | |||
+ | Mit dem Dienst '' | ||
+ | |||
+ | Je nach dem, **wie** der Dienst '' | ||
+ | |||
+ | Anbei die Konfigurationsdatei des Dienstes '' | ||
+ | < | ||
+ | # Tachtler | ||
+ | </ | ||
+ | |||
+ | Nachfolgend die **komplette Konfigurationsdatei**: | ||
+ | <code ini> | ||
+ | # URIs to check for running guests | ||
+ | # example: URIS=' | ||
+ | # | ||
+ | |||
+ | # action taken on host boot | ||
+ | # - start all guests which were running on shutdown are started on boot | ||
+ | # | ||
+ | # - ignore | ||
+ | # | ||
+ | # | ||
+ | # Tachtler | ||
+ | # default: # | ||
+ | ON_BOOT=ignore | ||
+ | |||
+ | # Number of seconds to wait between each guest start. Set to 0 to allow | ||
+ | # parallel startup. | ||
+ | # | ||
+ | |||
+ | # action taken on host shutdown | ||
+ | # - suspend | ||
+ | # - shutdown | ||
+ | # this settings since there is no way to distinguish between a | ||
+ | # guest which is stuck or ignores shutdown requests and a guest | ||
+ | # which just needs a long time to shutdown. When setting | ||
+ | # | ||
+ | # value suitable for your guests. | ||
+ | # Tachtler | ||
+ | # default: # | ||
+ | ON_SHUTDOWN=shutdown | ||
+ | |||
+ | # If set to non-zero, shutdown will suspend guests concurrently. Number of | ||
+ | # guests on shutdown at any time will not exceed number set in this variable. | ||
+ | # | ||
+ | |||
+ | # Number of seconds we're willing to wait for a guest to shut down. If parallel | ||
+ | # shutdown is enabled, this timeout applies as a timeout for shutting down all | ||
+ | # guests on a single URI defined in the variable URIS. If this is 0, then there | ||
+ | # is no time out (use with caution, as guests might not respond to a shutdown | ||
+ | # request). The default value is 300 seconds (5 minutes). | ||
+ | # Tachtler | ||
+ | # default: # | ||
+ | SHUTDOWN_TIMEOUT=60 | ||
+ | |||
+ | # If non-zero, try to bypass the file system cache when saving and | ||
+ | # restoring guests, even though this may give slower operation for | ||
+ | # some file systems. | ||
+ | # | ||
</ | </ | ||
FIXME - Hier geht es demnächst weiter... | FIXME - Hier geht es demnächst weiter... | ||
+ |
tachtler/virtualisierung_installation_wirt-system_centos_7.txt · Zuletzt geändert: 2014/12/09 10:02 von klaus